As a machine,if it is used for too long,its"retirement"schedule will begin,and then the machine will be in a scrapped state.As users,we naturally hope to extend its service life and improve its efficiency.So the editor would like to introduce to you a related knowledge on extending the service life of the Kaiping machine equipment,hoping to be helpful to your device.
A series of processing operations such as uncoiling,leveling,and cutting are referred to as Kaiping machines.The steel coil market commonly uses this machine to flatten and cut wide materials into higher specification coils or plates.Let's first introduce its mechanical principle.Kaiping machine mechanism There is an upper pressure mold on top,which is fixed on the push rod of the hydraulic cylinder.The cylinder body of the hydraulic cylinder is fixed on the bracket.Independent cooling channels are installed inside the upper and lower pressure molds,and their water outlets and water inlets are different from those on the upper or lower pressure molds.
Due to prolonged operation of the Kaiping machine equipment,some damage can be avoided.Everyone should pay attention to these minor issues,as the quality of their spare parts immediately threatens the extent of their damage.Due to the prolonged use of equipment,if the quality of the machinery is poor,it can damage the equipment,thus avoiding damage caused by quality as much as possible.
The sleeve roller chain of the device is composed of an outer transmission chain shaft pin and roller bearings.The specifications of the inner transmission chain and sleeve are that the outer transmission chain is tightened in conjunction with the shaft pin.
2.The specifications of the sleeve of the Kaiping machine are matched with the shaft pin transition,and the shaft pin can rotate freely to meet the expansion and contraction of the transmission chain when entering and adding chains.
3.As the damage to the transmission chain mainly occurs between the specifications and the shaft pin,a large gap should be maintained between the inner and outer transmission chains of the hoist to allow them to pass through its smooth sleeve.
The distance between the two axis pin lines of the device is called pitch,and the main parameter of the transmission chain is pitch.The carrying capacity of the transmission chain directly reflects it.If the Kaiping aircraft carries a large load,single row or triple row chain links with large pitch can be reduced to specifications,but the larger the span,the greater the average load per row,and it is generally not allowed to span three or four rows.
In order to not affect its use and extend the service life of the Kaiping machine,it should be fully utilized and maintained.Damage is inevitable during use.According to the left and right calculation methods,the actual wear rate during operation can be controlled within the range of the bearings,which can greatly reduce the damage to the Kaiping machine equipment in any normal damage situation.
Language
